How to connect the drone to Internet?

Overview of Device Connections

1. Connect through Wifi hotspot

1. Connect RC to local WiFi.

a.Make sure the firmware versions are above wlink 3.2.1.55 / ACS2_RC 2.1.1.40 (ARC3 Pro main board: 1.0.1.42.) (Offline update method available, check Chapter 3 of this manual)

• Turn on the remote controller, wait until the 3rd led of the RC turns off, indicating the RC is ready.

c.On XAG One App, open Me-Device page, click the 3-dot-button in the upper right corner, click RCN Mode, select Remote controller network connection, then click Wi-Fi SETTINGS.

From smartphone WLAN setting, choose ACS2 hotspot, then return to XAG One App, click Wi-Fi CONNECTED.

Click Internet connection settings, fill in hotspot ID and credentials, then click CONFIRM and CONNECT. The third light indicator of the RC will then flash yellow indicating that it has started to search and connect to wifi

3rd led Flashing yellow: pairing mode or connecting to local wifi

3rd led solid yellow: local wifi connected

2nd led off: IOT server not connected

2nd led on: IOT server connected 

Wait approximately 2 minutes until ACS2 voice prompts “connected” and the 3rd led becomes solid yellow indicating successful connection to the hotspot. Wait about 5 more minutes until all the second led turns on solid green which indicates the RC is connected the IOT server. The ARC3 Pro reacts similar but without vice prompt.