Chapter 4: 4G Networking Mode
      Back to home
      1. Help Center
      2. XAG Drone and Systems Technical Specification
      3. Chapter 4: 4G Networking Mode

      Chapter 4: 4G Networking Mode

      Introduction to 4G networking mode

      Use condition

      Good 4G network coverage

       

      Applicable models

      P100H/P100/P40CN/P40EN/V40CN/V40EN

       

      Device Pairing requirement

      Remote controller (RC) has a 4G SIM card inserted a.Second light (Cloud IOT) illuminates green

       

      UAV has a 4G SIM card inserted

      a.Second light (Cloud IOT) flashes green

      • Third light (WiFi) flashes green

      XRTK4 has a 4G SIM card inserted a.F1 light illuminates red

      • F2 light double flashes green

      Smartphone/Pad has a 4G SIM card inserted 

      Procedure: Device pairing under 4G networking mode.

      1. Remote controller (RC)

       

      a.Insert 4G SIM card into remote controller.

      1. Second light (Cloud IOT) illuminates green. c.Turn off the remote controller.
      2. Long press the power button of remote controller until all six LED light indicators flash green

      e.Open XAG One App, go to add device and input/scan remote controller serial number, input device name and confirm.

      f. Wait until the remote controller gets online; If not, kill and restart the APP

       

      2. XRTK4

       

      a.Insert 4G SIM card into XRTK4.

      1. Turn on XRTK4, wait until that,
      • F1 light stop flashes and illuminate red
      • F2 light double flashes

      c.Long press (2~3 seconds) XRTK4 F3 button, until F1/F2/F3 are flashing simultaneously, which indicates the XRTK4 is allowed to be added

      d. Open XAG One App, go to add device and input/scan XRTK4 serial number, input device name and confirm.

      e.Wait until the XRTK4 gets online; If not, kill and restart the APP.

       

      3. UAV

       

      a.Insert 4G SIM card into UAV.

       

      b. Turn on UAV, wait until both WIFI and Cloud light flash green.

       

      c.Open XAG One App, go to add device and input/scan UAV serial number, input device name and confirm.

      d.Wait until the UAV gets online; If not, kill and restart the APP.


      e.Bind UAV and RC